⊙The outer ring of drawn cup needle roller bearing is punched with the high-quality steel sheet. The outer ring has thin wall.
The drawn cup needle roller bearing has the characteristics of small radial section area, large load carrying capacity, less
inertia and economic manufacture. It is suitable for small section height, or when the housing bore isn't used for raceway, this
type is recommended to use. The bearing is assembled into the housing bore under a certain pressure without further axial
location.
⊙The drawn cup needle roller bearing generally takes its shaft diameter as the internal raceway. However, the proper LR type
inner ring can be used in accordance with application condition.
⊙The drawn cup needle roller bearing has two structures-with retainer and with full of needles. They are divided into openend
type and close-end type. The structure with retainer has the single seal ring and double seal ring. The structure with full of
needles has a large load carrying capacity.
⊙CWN can provide all drawn cup needle roller bearings listed in this catalogue, including standard size and non-standard
metric size, and inch-series as well as the high-precision drawn cup needle roller bearings with special requirements such oil
hole in outer ring, double-row needles, nylon retainer, inner ring, seal ring, etc. (special technical requirement on order).
[NextPage][NextPage][NextPage][NextPage][NextPage][NextPage][NextPage][NextPage][NextPage][NextPage][NextPage][NextPage][NextPage][NextPage]